Braehead Manse Gallery

Home / Projects / 3D Printer /

WP 20160508 09 52 48 Raw

WP_20160508_09_52_48_Raw.jpg WP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 RawWP 20160508 09 52 39 RawThumbnailsWP 20160508 09 53 00 Raw

The control and CPU electronics located on the left rear of the main frame.

In fact, this is the only real part of the kit that I'm really disappointed with. The PCB was engineered really for cost reduction by area. This means the connectors always get bunched and not placed into logical positions to allow for easy connections. This is then hampered because the 3 layers (of wafer thin) of plastic case don't really do anything.
If the PCB had been engineered against need layout (making it larger), then it would have been easy to connect things and easier to design a case that really supported and protected it.
Shame really.

Albums
Visits
578
Rating score
no rating
Rate this photo

0 comments